Arduino Nano¶
Pinout¶
Default system features¶
The default configuration includes those major features. They are all
initialized by sys_start()
at the startup of the application.
Drivers¶
Supported drivers for this board.
- adc — Analog to digital convertion
- analog_input_pin — Analog input pin
- analog_output_pin — Analog output pin
- ds18b20 — One-wire temperature sensor
- ds3231 — RTC clock
- exti — External interrupts
- i2c — I2C
- i2c_soft — Software I2C
- mcp2515 — CAN BUS chipset
- nrf24l01 — Wireless communication
- owi — One-Wire Interface
- pin — Digital pins
- pwm — Pulse width modulation
- sd — Secure Digital memory
- spi — Serial Peripheral Interface
- uart — Universal Asynchronous Receiver/Transmitter
- uart_soft — Bitbang UART
- watchdog — Hardware watchdog
Library Reference¶
Read more about board specific functionality in the Arduino Nano module documentation in the Library Reference.
Memory usage¶
Below is the memory usage of two applications:
- The minimal-configuration application is configured to only include the bare minimum of functionality for the low level kernel to run. That is, the thread scheduler and system tick.
- The default-configuration application is built with the default configuration, including a lot more functionality. See the list of Default system features above for a summary.
Application | Flash | RAM |
---|---|---|
minimal-configuration | 5526 | 741 |
default-configuration | 10820 | 842 |
Default configuration¶
Default Standard Library configuration.